Since I got so much good feedback on my judge my welds thread. I thought I would jump into welding head first. Good a good price on 20 in 14 foot pipe. The steel is 1/2 inch thick. I tried several places to buy end caps with no luck. But did find a place that plasma cuts to specs. So I ordered 2 plates with a 1 1/2 inch hole cut in the middle of each plate, an a 3/4 inch 2 inches from the edge cut in 1 plate. This is so you can add water. Got 2, 20 foot by 3/8 thick square tube. Had a few other pieces at home to complete.
This is the tube.
I’ll update when I had more to share
Sent from my iPhone using Tapatalk
This is the tube.
I’ll update when I had more to share
Sent from my iPhone using Tapatalk
Comment