recurve string selection

[Bisch]

When you shoot the bow, the yarn will all unravel. Then you can trim the puffs into nice tight good looking silencers.

Bisch

[bloodstick]

just under quarter inch. I have it on right. My top knocking point is brass and i tied the lower. I dont believe it is twisted the same as it was when i removed it. My brace height is at 7 3/4". Well within the 7.5-8.5"


Sent from my iPhone using Tapatalk

[DRT]

Shoot it some. As the string binds in the yarn it will adjust some. Give it 40 shots then check it. Within the range isnt close enough. Your bow will have an optimal setting for your DL and arrow set up.

Sent from my SM-J710MN using Tapatalk

[bloodstick]

I measured it the other day right at 8".
I knew i would have to let it settle in some. Just didnt imagine it would be a full 1/4"


Sent from my iPhone using Tapatalk

[DRT]

Yeah. Well when you get a new string it will surprise the heck out of you.

Sent from my SM-J710MN using Tapatalk

[DRT]

And the brace height affects noc height some too.

Sent from my SM-J710MN using Tapatalk