AR Handguards... Let's see em.

[Mike D]

SO... Mike did you get the chance to measure? That sounds bad... errr....

My 300 BLK DD will have that rail on it when it gets here so I may just see if I like it... but the 5.56 Noveske upper Im piecing together needs something... Not sure if im going with the regular N4 Upper Receiver or spending the extra coin for the VLTOR MUR, anybody have an opinion either way there?

Sorry Nate. Moving to our new place.

But it's only about 3/4".

[Coach W]

Dang that may be too close. The consensus sounds like it might be a little tight. Lol. Math has never been my strong suit so bear with me... Mikes supposed to have 1.5" of barrel hanging out the end...subtract the QD up to the attached suppressor at .75 and you have .75 left...

On a 10.5 inch barrel I need .75 to be eaten by the QD and attached suppressor... So the longest handrail I could go is 9.75...

That's if my math is correct. Please somebody correct me if I'm wrong. I'd rather be wrong before I order a handrail than after.

On a totally related note my 5.56 noveske 10.5 CQB came in today.

[Scopedope]

Just out a 15.5 inch Odin Works on my 16" 6.8. I really like it. http://www.odinworks.com/KMod_Forends_p/f-15-km.htm

[Coach W]

Just out a 15.5 inch Odin Works on my 16" 6.8. I really like it. http://www.odinworks.com/KMod_Forends_p/f-15-km.htm

Did you suppress it. If so it's there room for a mount and attached suppressor?

[Tilladaddy]

Did you suppress it. If so it's there room for a mount and attached suppressor?

I just ran an Odin Works on my 10.5 300 BLK build and they have the best dimensions for most suppressors to fit under the