I finally finished my project I have been working on for the past week. I needed to make a portable feed pen for the deer lease that didn't break the bank.
Ended up going with some 1/2 tubing for the frame and welded the hog panels to it. If I had to do it again, I'd move up to 3/4 or even 1". But with the 1/2 " it's still a one man job.
This little pin system is what I'm using to put them together. I will use wire in the bottom though
Finally all done, going to start with then and can add from there. Hopefully I can get them set up this weekend and see how it works in a uncontrolled environment.
Ended up going with some 1/2 tubing for the frame and welded the hog panels to it. If I had to do it again, I'd move up to 3/4 or even 1". But with the 1/2 " it's still a one man job.
This little pin system is what I'm using to put them together. I will use wire in the bottom though
Finally all done, going to start with then and can add from there. Hopefully I can get them set up this weekend and see how it works in a uncontrolled environment.
Comment