Ram 2500 leveling kit questions

[Arrowthreat]

Anyone running a 2.5 leveling kit on a 4th gen ram 2500? I installed a Hell Bent Steel 2 spacer on my 2011. It drives just like it did stock, however It's still not level so I'm thinking about putting a 2.5 on it. My question is do I need an adjustable track bar or any other components with the 2.5?

Thanks, Case

[brandon123]

Pics of before and after? I am considering the same thing.

[Boss Buck]

I would find a dodge ram forum and do some reading. when I read up on my level kit on 2011 1\2 ton the lift that make the truck level had small issue and wear stress on other parts so I went with 2". Did a lift kit second time around.

[Arrowthreat]

Pics of before and after? I am considering the same thing.

Man I don't have a before pic but I can take a picture of what it looks like now.

[BBReezen]

I did one on my 2012. 2.5" ready lift. It's not completely level but it's more than it was, I've got a Cattleman replacement on there so that might pull it down just a tad. I did not put any other aftermarket stuff on and have seen no issues. Prob 2 years at least on it.

[SB09]

You are good to go with a 2.5'' kit. Just accelerates wear on all the front end components is all. But, you were already doing so with the 2''. I don't think that extra bit is going to make much of a difference in that aspect vs. the 2''.

If you ever need ball joints, sway bars, tie rods I would switch those to Carli.

[Arrowthreat]

Ok thanks for the advice guys. It's got a brand new sway bar and tie rod ends so they should be good for a while.

[brandon123]

PM sent ArrowThreat.

[kry226]

I'm firmly in the full coils instead of spacers camp. But with 2.5", you don't "need" an adjustable track bar. I put a set of 2.5 T-Rex (predecessor to KORE) coils on my 04 Dodge Cummins and I never had an issue in the 12 years I owned it. But I could tell that the wasn't centered left to right under the truck. But if you didn't know what you were looking for, you'd never notice it.

[cmh2007]

In probably going to do the thurenfab kit on mine

Sent from my SAMSUNG-SM-G900A using Tapatalk

[SB09]

In probably going to do the thurenfab kit on mine

Sent from my SAMSUNG-SM-G900A using Tapatalk

Good stuff right there. Them and Carli are industry leaders for Dodge products in the leveling kit market

[TXUSMC]

When I do mine I'll use the Thuren springs, adjustable track bar and front shocks. I think it's $860 shipped. Quite a bit more than the $200 spacers but better ride quality and my axle will be centered up front. I also have a full front replacement on my 3500 so I hope I'm not disappointed with the leveled height.