axcel accutouch help

[bartosh317]

Glad you got her fixed up! I have the same sight and have it sighted in to 40 yards. Need to work on my tape and accuclicks here in the next couple weeks. Have an axis hunt coming up in April.

That's bad ***** man!! Good luck with you hunt and thanks for the advice again

[docmay]

Got some pencil marks set out to 100 yards. That's all I can get with my setup but that's what I usually shoot for. Was shooting well and I like the sight a lot. Good luck getting it set up!
Greg

[docmay]

Not sure if this will help you but here are some pics. I have 3 pins set at 20-30-40 yards. I used the bottom pin as the "floater" and sighted it in at 10 yard increments out to 100 yds. As I got each yardage dialed in I made a pencil mark on the white line. When I got home I set the accuclick deals to match the pointer to the pencil marks. Was short one click deal so skipped 90 and put one for 100 yards so I have a hard stop. I shoot some and make sure my pins and clicks are how I want them and pretty accurate. Then I'll match up a tape to those marks, trim it to fit and stick it on there. They first mark on the tape will be 40 yards and that is always where my sight will start.

[docmay]

Meant to send this as a pm but posted it. Oh well, maybe it will help somebody!

[bartosh317]

Lol its all good brotha, I ended up getting dialed in out to 60 the other day at the shop. I went back to 20 and was shooting a little low. I'm goin g to go back and run through all my yardages before I get the tape put on

[docmay]

Good thing is you can always tweek the 3 pins as needed to dial them in. Once that bottom pin is set the pin gaps should be consistent and stay the same.

[txdukklr]

I had a very rough time with the windage on my accutouch . . . . got it set now but it literally took me 3x longer then normal