Question on nock point height shooting 3 fingers under

[howie1968]

i am shooting a couple bows that are tillered for split finger shooters my 2 kodiak mags. I shoot 3 fingers under my question is would a 3/4 nock point height be to high. If i understand right a 3 finger under shooter shooting a bow tillered for split fingers should be about 1.8 higher thanks in advance for any help

[huntinpool]

Mine is 5/8" on a split tiller bow shooting 3 under. Your release and arrow combo will determine exact placement. I have shot quite a few bows tiller for split and never had any issues or noticable difference in nock height while shooting 3 under. Use a tied on nock and just screw it up slowly till you get the flight your looking for. There is about 1/4" range where flight isn't really affected but impact point can be adjusted.

[meangene1969]

5/8" is what I use.

[howie1968]

thanks men i appreciate it i had mine set at 1/2 and felt i was getting contact went to 3/4 it quieted down and groups were more to the center will try 5/8 tomorrow

[Bisch]

I shoot split but all my bows have nocking points around 3/4" high.

Bisch

[howie1968]

thanks Bisch

[Draco]

Mine is always about3/4" to 1" high. I have had bows that needed it to be over an inch high.

[caughtandhobble]

If I may add that bare shaft testing will tell you where the nock placement will shoot best for you. Most of my bows are 5/8" nock points.

[Selfbowman]

Debs is5/16 on her recurve. Mine is the same but I shoot split.

[Ron]

Mine are closeer to 5/8".

[bountyhunter]

Most of mine are around 3/8, but I either bare shaft or paper tune to get the right set for each bow.

[ShaBow]

Generally around 5/8 but sometimes go toward 3/4 it just depends on what the bare shaft tells me!