What's your favorite way to break in a new hunting rifle? NOT a match grade bench rifle.
Announcement
Collapse
No announcement yet.
Breaking in a new rifle
Collapse
X
-
Each manufacturer has there own guidelines for their gun barrel, I usually follow what they recommend. For the most it’s similar as hat bolilloloco mentioned in post #4. After break in I rarely clean rifle barrels unless it’s shooting bad, my guns like to run dirty or it ain’t no gun of mine haha
It helps with a little bit better accuracy and longevity of the life of the barrel by smoothing out any mill marks and burrs within the barrel, it doesn’t just magically make your gun shoot great.
Comment
-
I have experimented a few times with this, if there is a way to make a hunting rifle shoot better, I’m in. I found a website by speedy Gonzales, who is a benchrest shooter. Followed their guide and was impressed by the rifle after. I did not side by side compare with a rifle that I don’t follow instruction with. Of course this all depends on what you consider accurate!!! Do I want bullets touching at 100 yards with a hunting rifle, yes!! Most of my rifles shoot better than I do, so I want every inch. If you want to hit a paper plate at 100 yards, I wouldn’t consider that accurate. But it’s all in ones opinion, I don’t build rifles, I buy ones that are suitable for what I want, tikka and Sako, have not disappointed me on that. To make it simple, it was shoot and clean, a lot. I’ll see if I can find it again, but there is a science to it. http://www.benchrest.com/sgybreakin.htm
Comment
-
One of the rifles results,
This is hornady 243 whitetail ammo at 100 yards, I’ll take this all day. My 30/06 tikka with hornady factory loads will shoot through the same hole at 100 on a good day for my shooting. Oh by the way, After a few hundred rounds of reloads trail and error, I found that hornady shoots as good as I do.
Sent from my iPhone using Tapatalk
Comment
Comment