Anybody have any tips on doing it without buying the tool? I'm about 4 inches left at 7 yds. I had tritium sights put on at GT's when I got it. Trying to cheapskate it but I don't want to booger it up.
Thanks.
Thanks.
-
-
Could it be that your trigger control is causing the issue? If not, just get a delrin punch and drift it. -
brass punch and hammer tap rear sight to the right little at a timeComment
-
Trigger pull could always be the issue. I've had some good shooters run it and it is consistent.Comment
-
So to drift it it I should put it in a vice? I guessing 4 inches at 7 yds wouldn't require much?Comment
-
Have you shot it off of a rest? That will take out just about any human errors to be sure.Originally posted by Stoof View Post
If you're ever in houston you can borrow my BJ machine universal pusher. Otherwise, punch it like the others said (just be glad you're not trying to push an XDm sight)...Comment
-
-
Originally posted by sir shovelhands View Post
XDm sights are not terrible just have to be sure and use the big hammer
( Then clean the new dove tails up with a dremel and put some lock tite in there easily done)
OP if there is some slack on the side of the sight to the edge of the frame you can make it equal with a caliper. To move it like the others have said just a brass punch and hammer and put the slide in a vice.Comment
Comment