Need to borrow Glock site removal tool

[Hamshire]

Anyone in the greater SE Texas area have a 3/16" precision nut driver? I have some new sites I need to install on my Walther. I have a 3/16" socket, but it's too fat (thick walled). Just need to borrow it briefly.

Thanks!

[onetondodge]

I have an extra. Want me to send it to ya. You can send it back whenever you finish.

[BigTex.308]

This is what I use. It may be worth it to just spend the $8 on the tool.

http://www.amazon.com/Wiha-Driver-Precision-PicoFinish-Handle/dp/B001ID3APA/ref=sr_1_1?ie=UTF8&qid=1431568615&sr=8-1&keywords=3+16+nut+driver

I might have an extra one laying around somewhere that you can have. I'll check when I get back tomorrow.



Ike

[Hamshire]

Greatly appreciate the offer, fellas. I have an offer from a TBHer who is close to my work.

[bearintex]

This is what I use. It may be worth it to just spend the $8 on the tool.

http://www.amazon.com/Wiha-Driver-Precision-PicoFinish-Handle/dp/B001ID3APA/ref=sr_1_1?ie=UTF8&qid=1431568615&sr=8-1&keywords=3+16+nut+driver

I might have an extra one laying around somewhere that you can have. I'll check when I get back tomorrow.



Ike

X2 Buy it and put it in your range bag for when it loosens up on you. (not that that has ever happened to me at a match or anything)

[kmitchl]

Get a 1/4" socket head cap screw. They take a 3/16" allen wrench and will fit the glock sight screws. I bought a tool and this is what it was made from.