Case tumbler issue. Really weird!

[M16]

How do you dry the cases to keep them from getting water spots all over them? My OCD won't allow that, LOL.

First i drain them. Then I take them to my air compressor and blow them out. Lay them on a towel and air dry for a little while. No water spots for me either.

[Mike D]

First i drain them. Then I take them to my air compressor and blow them out. Lay them on a towel and air dry for a little while. No water spots for me either.

When I use my ultrasonic cleaner, I use distilled water. When they are done I shake all the excess water off of them then I lay them on a towel and roll the outside dry. Then I put them in the oven at 175° for about 15 min. They aren't shiny but no water spots.

[chewy]

Rotary tumbler with ss media is better than the ultra sonic cleaner based on my experience. Makes it look like new brass again inside and out. Lemie-shine Helps with the water spots. I just lay out in a towel or used my old food dehydrator to dry them.

I also used the ez rotary shifter and ss steel magnet when I pull the brass out of the tumbler.