Trying to remove the hand guards from my AR-15 but the hand guard is stuck. I am 100% positive that there are no more screws in it. It is the friction of the tight fit holding it on. It is the diamondhead VRS-t rail. I might just have to oil and muscle it.
-
-
Is it free float or attach to the delta ring and front sight housing/gas block? -
Is this the rail with two bolts on the bottom? Did you try to pry it open with a flat screw driver? Just be careful not to pry to much and mess up the rail.Comment
-
I got it now! I placed a sock over my upper reciever to protect from scratches, put some gun oil on where the handguard and barrel nut met. Got a small board and placed it on the handguard end next to the barrel nut and tap tap tap with a rubber hammer and off she popped.Comment
-
Glad you got it. Some guns pending brands use rock set which you have to let sit over night in water.Comment
-
Next time place your upper in a vice between two 2x4s if its a flattop and that will hold it firm while you work on it. Also Gerry yourself a good set of strap wrenches and a barrel nut wrench finally get a delta ring toolComment
Comment