Trick to Share If Your Sight Pins are too Bright

[dustoffer]

I was sitting in the stand last night waiting on the pigs, but they were no-shows as they were all ganged up at the calf feeder near the barn. But, I discovered my sight light was really bright as I had just changed the batteries. This morning, after my usual practice session, I removed the light, got some blue painter's tape, cut a small piece to fit over the light, and screwed it back into the sight housing. Went into the laundry room and turned out the lights and checked---perfect!!

[TXhoghunter94]

Thanks for the tip! I use a lot of electrical tape but it came off last week and I just about could have used my sight light as my bow light it lit everything up so much.

Sent from my SM-N910V using Tapatalk

[Husker]

Gaffers tape works great. You can apply one piece multiple times and reposition to cover more or less of the fibers


Sent from my iPhone using Tapatalk

[canny]

Another option is liquid white out. Coat the entire lens of your sight light and once it dries use your finger nail to scratch off a little bit in the center. I had to do that on my APEX sight as the light was way too bright.