Hello all,
I tried to get OT2 because that seems to be the most used/recommended software. Unfortunately after several emails back and forth I have found out that OT2 will not work on my computer because it is XP based. I didn’t realize that having windows 10 home still showed I had XP. Anyway I was told support was dropped for XP. So if somebody could run this through for me it would be greatly appreciated:
Current setup:
Bow: Hoyt Carbon Spider 30
Draw Weight: 70lb
Draw Length: 29”
Axle to Axle: 30”
Brace Height: 6.25”
ATA Speed: 332fps
Current Arrows:
VAP Armor Piercing
Spine: V1 350
GPI: 8.1
Shaft Length: 27.5”
F nock: 6gr.
Wrap: 7” - 7gr.
Blazer Vanes x3: 18gr.
Outsert: 43gr.
Field point: 100gr.
Total weight: 388.2gr.
Total speed: 301fps
What I want to go to:
Easton Carbon Injexion
Spine: 330
GPI: 10.2
Shaft Length: 27”-28”
G nock: 6gr.
One Stringer Wrap: 7” - 7.7gr.
Blazer Vanes x3: 18gr
Titanium Outsert: 50gr.
Field point: 100gr.
Finished weight: 450-480gr.
FOC: unknown
Speed: 270-280fps (just an estimate)
I hope I’ve given enough info. I ran this through another program and it showed no matter what I adjusted it showed up spined to weak. As in all the way weak. I just find that hard to believe. I didn’t want to over analyze an arrow build but a buddy recommended I try it and now I’m questioning my experience and the way I have always done it because a dang program says different. Lol Any help would be greatly appreciated. Thanks in advance
I tried to get OT2 because that seems to be the most used/recommended software. Unfortunately after several emails back and forth I have found out that OT2 will not work on my computer because it is XP based. I didn’t realize that having windows 10 home still showed I had XP. Anyway I was told support was dropped for XP. So if somebody could run this through for me it would be greatly appreciated:
Current setup:
Bow: Hoyt Carbon Spider 30
Draw Weight: 70lb
Draw Length: 29”
Axle to Axle: 30”
Brace Height: 6.25”
ATA Speed: 332fps
Current Arrows:
VAP Armor Piercing
Spine: V1 350
GPI: 8.1
Shaft Length: 27.5”
F nock: 6gr.
Wrap: 7” - 7gr.
Blazer Vanes x3: 18gr.
Outsert: 43gr.
Field point: 100gr.
Total weight: 388.2gr.
Total speed: 301fps
What I want to go to:
Easton Carbon Injexion
Spine: 330
GPI: 10.2
Shaft Length: 27”-28”
G nock: 6gr.
One Stringer Wrap: 7” - 7.7gr.
Blazer Vanes x3: 18gr
Titanium Outsert: 50gr.
Field point: 100gr.
Finished weight: 450-480gr.
FOC: unknown
Speed: 270-280fps (just an estimate)
I hope I’ve given enough info. I ran this through another program and it showed no matter what I adjusted it showed up spined to weak. As in all the way weak. I just find that hard to believe. I didn’t want to over analyze an arrow build but a buddy recommended I try it and now I’m questioning my experience and the way I have always done it because a dang program says different. Lol Any help would be greatly appreciated. Thanks in advance
Comment