Hey guys needing a little advice, I'm diving deep into learning as much about tuning as possible and am about to tackle adjusting axle to axle length. My strings and cables are in spec but noticed that my ATA is a little long as well as my DL a little off.I have read the Nuts and Bolts pdf. file on AT but could still use some advice.
When adjusting timing twist/untwists to one side will have more affect on opposite cam but what about when adjusting for DL and ATA?
In other words must you give attention to both ends of strings and cables when twisting or untwisting for DL and ATA in equal amount or would twisting/untwisting one side be fine like you would when timing.
Thanks
When adjusting timing twist/untwists to one side will have more affect on opposite cam but what about when adjusting for DL and ATA?
In other words must you give attention to both ends of strings and cables when twisting or untwisting for DL and ATA in equal amount or would twisting/untwisting one side be fine like you would when timing.
Thanks
Comment