Hoyt Ingite Draw Length Changing

[howabouttheiris]

Anyone know of a video online of how to do this? Supposed to be loosen screws, rotate, rescrew, without a bow press..... but I would like to see it done before I have 70lbs of cables and bits flying all over my garage.

Otherwise can someone gimme a quick step by step?

Thanks!

[BOWtechnicianTX]

if your talking about the new ignite, its really that simple. Remove the screw from the mod (should just be one screw). Rotate the mod to the desired draw length and put screw back in. Almost impossible to mess any thing up. PM me if you have any more questions

[DoubleGArchery]

I think there are 2 screws. One that fits the hole on the draw length. You can slide it to the length you need. I think on some of the lengths you have to move another screw in the cam, you will notice it needs to move. Both screws are the same size, and you can pull both out move cam and put them back in. Your ready to go. Good luck.

[howabouttheiris]

Thanks guys. Yes, it is the new 2014 Ignite. I just need to shorten it an inch from 29" to 28" (maybe 27") for a buddy of mine to give it a try and then back to my length. I'll give it a shot.

Supposed to be 'quick and easy'.... so 'quick and easy' that they don't bother to tell you how in the users manual.

[splitbeam145]

I think there are 2 screws. One that fits the hole on the draw length. You can slide it to the length you need. I think on some of the lengths you have to move another screw in the cam, you will notice it needs to move. Both screws are the same size, and you can pull both out move cam and put them back in. Your ready to go. Good luck.

x2

[onetondodge]

Super easy. Two screws on each cam.

[DoubleGArchery]

So did you get it to work?

[BGRAX]

Good info. My wife ordered one and we are waiting on it to arrive.