If anyone has one, do you have any idea what size set screw (or whatever it is) is holding the pin? I want to change my pin to a .19 but cannot get it loose. Tried the smallest hex key I have and it almost catches, but then spon. The next size larger is too big. Puzzled and frustrated. The CS at TR has been fantastic as they sent me a .19 pin for no charge, but they have not answered my question on this so I thought I would ask the GS. the set screw is located at the base of the aperture right underneath the pin.
-
-
Maybe be metric -
Tried .05 standard and was too small, 1/16" was too big. 1.5 in metric was too big. Can't find a smaller metric in town.Comment
-
If you can't get it figured out this weekend, give them a ring tomorrow (Sunday). They should be able to tell ya the right size.Comment
-
Going to call tomorrow and find out.Comment
-
I know this is a late post, but I am new to the sight. Why are you changing to a 0.19 pin? Did you have the 0.10 pin and not like it?Comment
-
With my age and eyesight, the .19 pin is easier for me to see.Comment
-
mudslinger
Mudslinger....Im not sure if you use your Facebook much but can you check your page...I sent you a message there. Im not able to PM here yet since this is my first post........ ThanksComment
-
Will do.Comment
Comment