bh questions

[TexAg2002]

I bought a pack of NAP Bloodrunner BH last week and noticed when I put them on that they contact my riser at full draw. The only way to make them work is to turn the shafts on the nock. Will it matter that the fletching marking my nockpoint it not pointing up anymore?

[clcraft]

I have shot with cock feather up, and turned with cock feather pointing out. No difference with my drop away rest. WB Rest could cause problems.

[gatt40]

Shouldn't make much of a difference, but turn it and shoot to be sure.

[R. Gauer]

I put a small rubber O-ring over my broadhead threads which allows me to tighten my broadhead so the blades line up with the fletching or whatever orientation that you choose. The 0-ring makes the broadhead tighten up sooner.

[TexAg2002]

Should have mentioned I am shooting a WB.

[ra61hunting]

It shouldn't matter.

[TexAg2002]

Bump

[dpg481]

What head were you using before. If the head hits the riser it seems like the rest is too far to the inside. You may have a bit of a tuning issue.

[TexAg2002]

What head were you using before. If the head hits the riser it seems like the rest is too far to the inside. You may have a bit of a tuning issue.

I was using muzzy fixed blades. I know my centerline is good. The 2 blade expandables are wider and line up flat before I turned the shaft.