Hello everyone:
I just got a new Tenpoint Titan Extreme today.
After a few shots I had it dialed in with my field tips.
I went out then at 30 and 40 yards and things were pretty good.
I put the rage practice tip on and fired at 40 and was surprised to find I was off low and to the left about 2 - 3 inches.
I was expecting low but not to the left.
I moved back to 20 yards and it was the same low and to the left.
I finally after a lot of adjusting got it back dialed in.
I have seen where most say they are about the same as field tips. Any suggestions as to why it was off?
I was using both a 125 grain field tip and 125 grain rage practice tip.
Using the bolts that came with the bow- carbon
The tip was cleaned well removing all the foam after pulling it from the target.
The tip was tight and not loose.
Is it possible the tip and bolt are not matched and I need a stiffer spline?
Thanks in advance for the help!
I just got a new Tenpoint Titan Extreme today.
After a few shots I had it dialed in with my field tips.
I went out then at 30 and 40 yards and things were pretty good.
I put the rage practice tip on and fired at 40 and was surprised to find I was off low and to the left about 2 - 3 inches.
I was expecting low but not to the left.
I moved back to 20 yards and it was the same low and to the left.
I finally after a lot of adjusting got it back dialed in.
I have seen where most say they are about the same as field tips. Any suggestions as to why it was off?
I was using both a 125 grain field tip and 125 grain rage practice tip.
Using the bolts that came with the bow- carbon
The tip was cleaned well removing all the foam after pulling it from the target.
The tip was tight and not loose.
Is it possible the tip and bolt are not matched and I need a stiffer spline?
Thanks in advance for the help!
Comment