Fletch question when switching to whisker biscuit

[TICK MAGNET]

I finally made the decision to switch to a WB. Which vanes are best to shoot through it, and should I do helical, offset or quick spin? It would seem like the quick spin edges would grab on the WB fibers as it passed through. Im not sure if it matters, but I shoot a fixed blade broad head.
Thanks for the advice!

[rocky]

Helical Blazers.
I fletch my shafts with the Arizona EZ Fletch Mini.
Lots of helical, and Blazers are tailor made for the Biscuit.

[El Coyote]

Helical Blazers.
I fletch my shafts with the Arizona EZ Fletch Mini.
Lots of helical, and Blazers are tailor made for the Biscuit.

How do you keep the mini clean? Mine gets all gunked up.

[rocky]

How do you keep the mini clean? Mine gets all gunked up.

Acetone

[Skullworks52]

I haven't had a problem with any tough like blazer vane. Vanetecs or Blazer with a helical like Rocky said. I have a bitzenburger jig and haven't had a problem with them coming off. If I re fletch arrows I scrap off the glue and such then take 600 grit sand paper and sand it a bit to help out. then wash it off with water and dry. Then take a paper towel and clean the shaft with 92% alcohol. Haven't had a vane come of by a biscuit.

[Loco-fixer]

I also am trying whisker biscuit for first time. My hunting arrows are fletched with helical feathers. Will this be a problem?

[Hunter66]

I have had no problems, but Iam pretty old school.

[Skullworks52]

I also am trying whisker biscuit for first time. My hunting arrows are fletched with helical feathers. Will this be a problem?

I haven't seen a problem.

[TICK MAGNET]

Thanks guys! I'm going to get some new arrows this week and will stick with the offset blazers.