Sight problem.

[Graysonhogs]

Recently switched to a single prin sight(range rover) and have a problem. I got the elevation adjusted fine. The problem is by the time I got windage tweaked in I can see my cables in my sight window. Could my rest be off? Never had
This problem before. I'm fairly new(1 year) to archery so I'm sure it's something simple.

[cactus kid]

Could be :

Center shot
Too long draw length
Hand torque

[Graysonhogs]

The draw length is good. Would hand torques be an
Issue just drawing back? What is center shot? Pardon my ignorance.
I had no problems with my four pin sight . This one is sighted in, but seeing the cables is no buenos.

[Graysonhogs]

Ttt

[cactus kid]

Who set your bow up?

[GregO]

Is the housing on the new site larger than the old one?

[Graysonhogs]

.1" smaller.

[Bigdaddy]

Could be a second axis issue

[Graysonhogs]

Could be a second axis issue

What do you mean?

[Graysonhogs]

It's all jacked up. Just notice that my fletching isn't clearing the cables. It's like everything got pushed to one side. Ginna have to take it in.

[txnduckhntr]

mine did the same thing and i freaked out and panicked, tookit in and the cable had slipped out of the plastic slide and the bar the slide slides on was backed out and leaning,i felt stupid...just a thoughht

[2012DXT]

Something ain't lined up right.. Can't imagine what could've gone wrong with just a sight swap. Hope you get it figured out!

[Graysonhogs]

I don't know what happened. I'm
Gonna take it in to get looked at. I'll post what the proble
Was when I find out.

[2012DXT]

I don't know what happened. I'm
Gonna take it in to get looked at. I'll post what the proble
Was when I find out.

Good luck to ya'! Hope it's a cheap fix!

[Kdc]

mine did the same thing and i freaked out and panicked, tookit in and the cable had slipped out of the plastic slide and the bar the slide slides on was backed out and leaning,i felt stupid...just a thoughht

I'd check this first before I took it in, easy to check and just as easy to fix.