2013 Elite Hunter Tuning Specs

[Bisquick]

I'm changing my cables tomorrow and was wondering if anyone had the 2013 Elite Hunter Tuning Specs.


Posted from Texasbowhunter.com App for Android

[Daniel75]

PM Jerry R, he might, he sells them. Or PM Cajun Blake.

[Razorback01]

You can get the 2012 Hunter Tune Specs from the Elite website, I would think they would be the same, maybe verify with Elite Customer Service as they have always been a good source for me.

[Bisquick]

The only problem with the older hunter. is that they completely redesigned the 13 hunter and the specs are fir the 11 hunter. And there is no one in there office because of the ata.


Posted from Texasbowhunter.com App for Android

[12RingKing]

They should be in the office tomorrow. Try again then.

[Bisquick]

Yes but I was going on a hunt this weekend. So I was needing it today.


Posted from Texasbowhunter.com App for Android

[12RingKing]

If I was you I'd get the poundage and Dl right....then pull it on a drawboard and see how they sync at full draw....

Do the new cams still have the timing dots?

[Bisquick]

That was my plan and I was going to compare to my old ones. and yes they still have the dots on the cams. Thanks for the input.


Posted from Texasbowhunter.com App for Android

[wassaw]

if it was me in this situation.
I would take the old cable's, measure their length at 100lbs tension and twist the new to be at same lengths under 100lbs of tension
mark the cams with a pencil with old cables (under the limbs)
mark the cams with a pencil mark at the limb (when new cables are installed on the top of the limbs). shoot it 25 times and check the marks to see if they moved. twist if needed to put the marks back in the correct spot.
(plus check all specks, draw weight, draw length most important)

[Hornytoad]

Here are the specs on the 2013 Hunter which include the string and cable lengths. As Wassaw said the strings and cables need to be measured under 100# tension. Get the DW and DL right and you should be good to go as long as you are within 1/8"+/- of ATA and BH.

good luck

Specifications

Axle-Axle

31 1/2" +/- .125"

Brace

7 3/4" +/- .125"

String

54 7/8"

Cable

36 7/8"

Centershot

7/8" - 13/16"