Best way to install Lighted nocks??

[jimmyneutrontx]

Switching to Noctural Lighted nocks this year. What the process for changing out nocks on Carbon Arrow.

[TX_H-F]

pull your old nock and index the new nock just like the old one

[jimmyneutrontx]

Thought it was that simple but searched the web and there was a whole process of heating the old nock pulling it, sanding inside of arrow and gluing new nock in

[TallTexan]

pull your old nock and index the new nock just like the old one

This is what I did

[SAGEBRUSH ASSASSIN]

Thought it was that simple but searched the web and there was a whole process of heating the old nock pulling it, sanding inside of arrow and gluing new nock in

That is for changing inserts.

[wsteffen]

This is what I did

same here

[Spoken0313]

I wrap mine with a little thread tape before I insert them, helps make a tight fit and not add any significant weight

[TX_H-F]

you dont want to glue them. they should fit your arrow snug if you buy the right size. if you glue them its not so easy to replace them or index when tuning your bow

[SMOOTHboar]

Take a piece of plastic wrap large enough to wrap the entire nock. Then simply index the nock and press it firmly into place. finally trim a way extra plastic.

The plastic makes a snug fit, does not add significant weight, and allows for easy removal should the battery go dead or nock gets busted. Cheap too and chances are you have some kind of thin plastic around that will work.

[Free q2]

Make sure you put it in the back of arrow.