stabilizer quick disconnect

[Husker]

Probably asking a dumb question but what size disconnect would I need for a Stokerized standard hunter stab?
I see them on google listed as small and standard and find no reference as to the difference in size.
Any recommendations...want the bow to look pretty too so would like one in lost camo to further accent the copper colored glass tube on my stokerized stab. Kind of wishing I'd of gone with the concealment version as I'm not too sure yet about the bling factor of the copper glass tube.

[bowhuntntxn]

Any of these will work, and I could not find any in any camo pattern

http://www.lancasterarchery.com/bow-accessories/stabilizers/quick-disconnects.html?

[Husker]

This is the one I found just would like know if the "small" fits the appximately 1" diameter of the stokerized?

http://shop.eaglearchery.com/browse.cfm/specialty-archery-quick-disconnect-small-lost/4,10845.html?AFF=BASE

[bluelund79]

The doinker quick detach is 1". You can always have the housing sent off to a dipper if you want it to match...

[BRobbins]

The doinker quick detach is 1". You can always have the housing sent off to a dipper if you want it to match...

or these days, dip it yourself. fairly easy kits and good instructions on youtube.

[JSF]

why put a quick connect on it when it just screws right out?

[cricman]

I use quick connects because I have 2 bows that don't have the stainless insert. Screwing and unscrewing a steel screw with a lot of weight at one end, into an aluminum riser can be murderous on the threads. Even with a stainless insert, it can be hard on the threads to remove and install a stabilizer over and over. Once the base of the quick connect is in place, the threads, of the insert or stabilizer, don't get worn out, or cross threaded. The other reason is the obvious one. Two turns of the stabilizer, and it's off the bow.


cricman

[Husker]

This is the one I found just would like know if the "small" fits the approximately 1" diameter of the stokerized?
http://shop.eaglearchery.com/browse.....html?AFF=BASE

Manufacture emailed me back and says that the small is 1.015" Which would of been perfect....but I got in a hurry and ordered one of the jimposten instant disconnects. Hopefully it'll work out better as I wanted one so I could easily switch to my diy hoglight stab. This should do the trick and was just a little more money than buying two of the others.