beman mfx micro question?

[Phoenix]

I bought some beman mfx micro arrows. My field tips and rage mechanicals don't screw all the way in because of micro shaft. Is this how they were designed to be shot or do I need some sort of accessory? Was shooting beman ics...... will these arrows change whole dynamics of my setup?

[Bowtech32]

Mine screw all the way in, sounds like they put too much glue in it....

[Phoenix]

The threads go all the way in but where the feild point or broadhead is usually counter sunk in shaft ..... that part is still out of shaft. Threads flush with arrow end.

[plentl65]

Are they suppose to be the hidden inserts? As said above they either put too much glue in or didn't push the inserts all the way back

[rocky]

Sounds as if they either didn't get the insert deep enogh, or filled the threads with excess glue.
They should hit the shaft.
If the micro shafts are smaller diameter, you will need to re-tune.

[Phoenix]

The insert is flush with end of arrow! Good ol BPS in Shreveport does it again! Should have asked y'all about these before I drove 1 1/2 hours to stand at archery table for 45 minutes waiting to be helped only to have them Jack my arrows up! Reminds me of when I got a haircut at a wal-mart by a laid off brick layer! He jacked my hair up so bad just shaved it off myself!!! Going to have to take em back I guess?

[rem788]

Yep they messed them up. The inserts on those arrows are supposed to be inset in the shaft. There is a little tool that has the exact length already set so you just glue and use the tool to push it down then let them dry. Did they already cut them? The ones I bought already had the insert in but I had them cut to my length which removed the old insert, so I just glued in new ones.

[WyoHunter]

Like Rem788 said........ They didn't use the little tool that seats the insert to the proper depth.

[Booger74]

Heavy Arrow, but great KE!

[rem788]

I would take them back and get new ones.

[dipstick105]

they diffenetly didnt set the insert rite, i shoot this exact arrow and there is a little tool that you have to use to set them rite, if the tool is not used you will have jacked up arrows.....

[Phoenix]

I called BPS and they said they would make it right..... hope that means they will take into consideration the 3 hour round trip each time I have to go over there! Said they had two new guys working archery shop last night...... Hope it works out? Thanks for the help!

[wellingtontx]

Too much glue

[Tkshu22]

Love these arrows

[Mojo]

great arrows...if you trim your own arrows to size, you need to REMOVE the insert BEFORE you cut to length...propane torch and a fpoint installed, heat the area where the insert is a little til' you can pull the tip out...uses hot melt glue to put back in, or rod tip glue also...to re-install, screw fpoint into insert first and back it out about2 threads visible, put some hot melt on the insert, not too much to make it messy, then force the tip back into the shaft and viola!!!...
I cut my own arrows and use the mfx's too....