Z7 question for the bow experts

[bwkozak]

Ok, on my limbs there is about an half inch between the bolt. What will happen if I tighten it down all the way? I have really never messed with bows. I just shoot'em. If I have a problem I will take it to a bow shop, but I'm not happy with the one I used. I'm just woundering if it changes my poundage. It is set at 63lbs right now.

[Sparkles]

It's only like that on one limb? And yes it will change your draw weight.

[bwkozak]

Thanks, I kinda thought that but I was not for sure. No both limbs are backed out about the same.

[Sparkles]

Ok good if it were one you would have issues. By tightening them down your draw weight would increase.

[scott123456789]

On most posts each full rotation gives you approximately 2.5 pounds of increase or decrease.

[Osceola]

Don't screw it all the way down leave it a 1/4 turn out.

[DrenalinJunkie]

If you deside to start cranking on it...... BE SURE. To do each limb the same!

[bowbroadhead]

Don't screw it all the way down leave it a 1/4 turn out.

correct, mathews suggests not to bottom out slim limbs