Replacing Rage blades

[HeloMed1]

Has anyone done this before or do it regularly? I just replaced the blades in 6 of the 2 blade and it was a giant pain in the rear end. It is almost worth paying the extra $20 and getting three new ones and a practice head. Maybe there is an easier way to go about it than what I was doing?

[wheels]

The ones with allen head screws, no problems, the ones with pins i gave up on and threw them away.

[bloodtrailer]

Try cleaning them up and just Sharpin the blades.

[Leftridge]

Ya, i did that once..Never again..The roll pins were SUPER hard and even with a punch they were a PITA to get in.. I thought they replaced the allen wrench with the pin..Guess its the other way around..

[NelsonV]

Easier to buy more.

[Slew]

I wore leather gloves, used a punch, and had help! Its a PITA with the roll pin ones. Almost woth the extra $20 to avoid a trip to the ER!

[Bodey]

The allen screw set up is a piece of cake if you have your glasses on. I remove them to replace or resharpen the blades.

[Lowe]

I replaceed blades in 3 heads with the roll pens a couple of months ago and will definately just buy the blades next time. I ended up drilling a hole in a short 2X4 to drive the old pin into with a punch but well worth my $20 to buy new heads next time.

I believe the instructions say to use the new replacement pin to drive the old pen out....????

[mhbaseball]

I just bring them to academy to exchange them if they break too soon....academy backs all its products