X
-
Originally posted by ctom87 View PostThanks for the tip! Umfprtunately for me it was a brand new carbide tip!
I took a 60 grit belt sander to it while it was on the lathe at 2400 rpm. That really hogged it out quickly. Went to 80, 150, 220 and 320 afterward...
Sent from my SM-G781U using Tapatalk
Comment
-
Originally posted by Banded Drake Calls View PostI've had it happen to me sometimes on the end grain. Some walnut I have is notorious for it, even when my tools are sharp. Like you, I just start with a low grit sand paper til it comes out then run up in grit for my finish. You should look in to stabilizing. It's a whole 'nother world to get in to, but I stabilize some pieces now before turning and they don't give me that problem
Sent from my SM-G781U using Tapatalk
Sent from my SM-N9600 using Tapatalk
Comment
Comment