DIY/ build along hydraulic Shredder

[Fla Hunter]

Nice!

[refugioco]

Awesome!

[blntrey3]

Wow!!!

[HainesNYT]

Video is done!!

https://vimeo.com/160954791

[HainesNYT]

** for the record, the blades were not spinning when I pushed over the dead oaks...I would never lift the deck that high with the blades spinning...it was a demo to show the "push-bar" capability***

[Big H]

I like it. Very impressive.

[HainesNYT]

This is my go to thread, can not wait for the video.

ttt for some video of this beast in action

Video is up!!! Enjoy

[Texas Grown]

Nice video! I think you have Torro mowers beat a little .

[woodsman08]

Thanks for sharing the video. I bet this thing will outlast a few skid steers.

[Jbonds99]

Awesome build

[HainesNYT]

Nice video! I think you have Torro mowers beat a little .

Thanks for sharing the video. I bet this thing will outlast a few skid steers.

Awesome build

Thanks everybody! I am hoping to pick up the sheet of 3/4" steel tomorrow and bring it to the guy with the plasma table tomorrow. I would like to have him cut a ROUND carrier for version 2.0 I ordered a new, weld-in, hub for the splined shaft. I'll keep y'all posted.

[woodsman08]

any updates on the 3/4" carrier HainesNYT?

[HainesNYT]

any updates on the 3/4" carrier HainesNYT?

Steel is at the shop with the CNC plasma table. I hope to have all the specs for him and sent off by this evening.

I am going to have him cut one for my personal 72" cutter as well

[HainesNYT]

Have had several scheduling conflicts, partly do to my travels for work...making progress now



Bryan, at Zinfab in Castroville, is doing the CNC Plasma Cutting for me. This blade carrier should work for both 60" and 72" cutters....depending on the blade size. I'll keep y'all posted on the progress for the neighbors 60" and for the mods I'll be doing to my 72"

[Texas Grown]