Arrow Saw

[SwampRabbit]

Needed to cut some shafts. Already had a dremel so I just picked up some aluminum angle and a couple 2" U bolts. The wood and fasteners I already had.





The shaft lays in the chanel and the plate slides.

[bassmatt72]

That looks pretty good! Might take some ideas from it and redo my diy arrow saw?

[Grillndeer]

looks like a winner

[GlenB]

Nice! That'll work.

[BenBen]

As long as you use a squaring device to clean up the business end you are golden. Looks great.

[doeslayer_08]

Cool deal. I just made one too. Got a small cut off saw at harber freight for about 30 bucks. Works great.

[SwampRabbit]

As long as you use a squaring device to clean up the business end you are golden. Looks great.

It cuts it square. The shaft slides perpendicular into the blade, like on a miter guide.

[BO-N-ARO]

CAUTION!! Make sure you take care of the carbon dust. Use a vent fan and or respirator when cutting carbon shafts. A shop vac can help when you place it in the right place. A wet towel lawing under the saw can help collect the dust. You do not want to inhale the dust.
The saw looks like it can work, nice design!!