This is what I do. Small diameter, high pressure, hydrolic lines for deep water oil well control systems. And yes all those welds in the box were done by hand. Some on the bench and some in the box. I love my job!
good lookin cap on a full pen sump weld on a compression vessel... had to repair the other guys work because he had no full penetration and his cap didn't meet the correct size...
uphill weld on 1 inch plate with a 35 degree bevel, heat treated and 2 test done on it, 1 test was a pull test, couldn't pull it apart, 2nd test was a bend test, couldn't bend it under the desired maximum pressure.
Coon007 and I built this 6 wheel skid steer a few years back. Trailer and everything was built up from scratch. Used a 15 horse Honda to power it and everything runs thru hydraulics. Clocked it out at 38 mph and could crawl over anything except wet clay
Comment