This is my first go at building one of these. I needed something to save my roof from the abuse I was putting it through hauling full length steel on the cab and tailgate. I will also be building a detachable H brace to come off my rear bumper and get the weight off of the tailgate, which I've already dented as well.
Setting up the angle iron. Had to trim the edges a bit with the plasma to get them to fit right. I went with full length so I could weld on some D rings as tie down points.
Initial uprights tacked up and checking the fit
Setting up the angle iron. Had to trim the edges a bit with the plasma to get them to fit right. I went with full length so I could weld on some D rings as tie down points.
Initial uprights tacked up and checking the fit
Comment