Picatinny rail mount

[stxhunter]

Anyone ever mounted a picatinny rail to a stabilizer hole? I have a light I would like to mount onto it.

[zaustin13]

I would be interested in this too. What about mounting the rail directly to the stabilizer and/or a picatinny riser to it? When hunting out of a ground blind, my sniper hawglite is a little too low and hits the side of the blind.

[Texastaxi]

Like this?

http://www.texasdirecthunting.com/servlet/the-192/bow-rail-drc-dual/Detail

[Blue Tick]

Like this?

http://www.texasdirecthunting.com/se...rc-dual/Detail

^^^^^^

[stxhunter]

Yup, like that. I'm looking into getting them made at a machine shop. The prices seem a bit high to me.

[Bill]

Buy a picatinny rail on amazon.com for around $10 and either JB Weld or screw it into your stabilizer.

Good to go.

[arrowdiger]

Like this

[Blue Tick]

Like this

Did you make that little jewel?

[stxhunter]

Like this

VERY nice!

[arrowdiger]

Yes I did. I was thinking about making few more and putting the up on here.

[stxhunter]

I'm not saying I'm having these made, but hypothetically speaking if they were $25 do you think something similar to this would sell?

[Bill]

The Magpul hard plastic rail is $6 at a local gun shop.

[Bill]

I'm not saying I'm having these made, but hypothetically speaking if they were $25 do you think something similar to this would sell?

No way to machine that for &12 to sel for $25.

[stxhunter]

No way to machine that for &12 to sel for $25.

If I could get that machined out of aluminum and anodized would it sell for $25-$30? I'm not saying I could do it for $12 just asking if it would be a good value at $25? I know I would buy it just not sure of others out there.

[Goldeneagle]

Just now seeing this. By time you get them machined AND anodized you will have close to $25-30 in each one maybe. I'm checking for ya though.