Have a northern tool 3100 cfm pressure washer, been running great, has new plug air filter, oil has been changed. Used it several hours no issues, bout a week later, fired it up first pull, used it about 20 minutes, it died. Drained bowl, started again ran about 5 minutes. It starts runs a few minutes then dies. Any suggestions on how to fix.
Announcement
Collapse
No announcement yet.
Pressure washer issues
Collapse
X
-
See if there is a screen on the muffler. If there is pull it out. Sometimes the screens get clogged up and creates issues.
And this might help.....he has a ton of good info
[ame="https://www.youtube.com/watch?v=aMsAdVerbvs"]How To Fix a Lawn Mower That Quits, Dies or Stalls After 2 Minutes - YouTube[/ame]
-
Just recently I had a nearly new trash pump give me similar problems.
Gas fine, carb shiny clean, air filter fine, tested spark and looked fine. It would start up the first pull but after a bit would die and then become hard to start. I replaced the ignition coil and that fixed it. I'm guessing it would get hot and the spark would become weak. It was odd being it was so new.
Comment
-
Originally posted by Wits_End View PostJust recently I had a nearly new trash pump give me similar problems.
Gas fine, carb shiny clean, air filter fine, tested spark and looked fine. It would start up the first pull but after a bit would die and then become hard to start. I replaced the ignition coil and that fixed it. I'm guessing it would get hot and the spark would become weak. It was odd being it was so new.
Comment
Comment