Reloading Brain Trust- Who made this?

[Bucknaked]

So I had listed it In The classifieds as a Lyman because that was the box it was in. I used to purchase large lots of reloading accessories and this came in one. I called Lyman and they never made a Press mounted puller with collets. I’ve been searching but I can’t find any information on it. There are No brand markings on any of it.

[M16]

Looks like RCBS. But you’d think it would be marked.

Checked mine and die and collets are marked RCBS. Looks the same but yours must be a different brand.

[Bucknaked]

Looks like RCBS. But you’d think it would be marked.

The collets are different and numbered different . Rcbs has everything marked

[Bucknaked]

Up

[WyoBull]

Looks like my RCBS puller. May just be an off brand, private label puller but I would bet the RCBS collets would fit it.

Sent from my SM-G965U using Tapatalk

[Bucknaked]

Anyone else?

[ra61hunting]

If these are older they may be from Herter's. I have some older Herters dies with same look and finish.

[Bucknaked]

If these are older they may be from Herter's. I have some older Herters dies with same look and finish.

I would say that the set is quite old! I found some herters collets on EBay and they are a bit different.

[ra61hunting]

I would say that the set is quite old! I found some herters collets on EBay and they are a bit different.

It was a shot in the dark. Good luck

[Bucknaked]

It was a shot in the dark. Good luck

Thanks!

[Hotrodd]

Forster?

[Bucknaked]

Forster?

No Sir- I have a Forster also

[Matt_C]

Looks like a early RCBS unit.

[Bucknaked]

Looks like a early RCBS unit.

Possibly! I have the RCBS also but the knurling on it is much shorter and the threads much longer. I don’t recall rcbs ever using chromed locks either. I’ll contact them . It sounds like I do a lot of boolit pulling but I don’t do much at all.

[Draco]

Not RCBS. Mine is from the early 70's and it has the caliber on the collets.