Can someone run this through a spine calculator for me?

[justletmein]

My subscription expired. I just want to check this and see how close I am to optimal before I have the arrows cut, can go as short as 26.5" carbon to carbon or an inch or two longer if it makes a big difference.

I'm shooting a Bowtech Revolt 70 lbs maxed out. I want to say on the pull it was 71 lbs. but I don't fully remember.
IBO Speed: 335
Letoff: 85%
DL 29"

Arrow I'm looking at is the Easton Axis 4mm Long Range (not Pro).
Spine 300
GPI: 9.3
Nock: 10gr
Fletching: 19gr
Head weight: 100gr
Length: 26.5" minimum carbon to carbon, 27.5" minimum if the half-out length counts.

[Fishndude]

Which half out? 50 or 95?

[justletmein]

Sorry, the aluminum 50 that it comes with.

[justletmein]

Sorry, the aluminum 50 that it comes with.

They do have an option for 55gr Titanium half-out and also the heavier deep six but I wasn't really exploring those options.

[justletmein]

Bump?

[justletmein]

Anybody?

[Big Ace]

Give me a min and I’ll post a pic.

[Big Ace]

I got you down for this setup :
335 ibo
29” draw
71 lb
7.25 BH
30” ATA
85% let off

Arrow
100 grain point
50 grain insert
29” arrow
6.33 fletch
3 fletch
2.75 fletch length
10 grain nock

[justletmein]

Awesome! So I actually need to cut these a little longer rather than shorter then. Thank you sir!

[jds247]

Awesome! So I actually need to cut these a little longer rather than shorter then. Thank you sir!

I run mine in that stiffness range without any issues..you can cut them longer if you want but as is won't hurt you. .I prefer a stiffer arrow myself ..