Tundra Experts

[rvd]

Thieves made the first cut ahead of my passenger side catalytic converters before I walked out of Katy mills mall yesterday (about 2pm on a busy Saturday) and caught them in the act, they drove off before I could reach them.

Question is will all the warning lights/codes that came on during my very loud drive home go away after I reset and patch the cut? The cut is clean and straight and nothing else was damaged that I can see.

Katy PD was wonderful btw, and had a suspect within 5 minutes from my description and video footage. It’s bad out there…

[bbqfan5909]

Weld it and flash computer, should be good to go!

[rvd]

Weld it and flash computer, should be good to go!

What I’m hoping! Thanks

[Johnny Dangerr]

Catstrap.com
Did my Tundra last week...

[rvd]

Saw those, think I’m going to do a plate, thanks. Why’d you go with that over a plate?

[tps7742]

Interesting Mr Danger I will have to check this out. Thanks again for sharing your knowledge from your profession.

[Johnny Dangerr]

Interesting Mr Danger I will have to check this out. Thanks again for sharing your knowledge from your profession.

Dustybritches started a thread on them. My Tundra is 19 years old and no one makes a plate for it. Been looking for a solution for 18 months. These take a 5 minute job to a 30 minute mess. This company has a motion detector that is screaming loud. I still may buy it - and it might be all you really need.

Parts and labor 350.00...

[Maddox]

I went with the plate installed by Toyota Country off Hwy 249.

I have yet to get the oil changed since installing it so I’m not sure how big a pain that will be.

[Smart]

I went with the plate as well ..... Desert Eagle Off Road

[Mayhem]

Weld it up and clear the codes and hope for the best.


Sent from my iPhone using Tapatalk

[rvd]

Had exhaust welded yesterday, cleared all the codes and drove 200 miles, so far so good. Appreciate the help.