Krivoman setup help with platform

[bear]

Built a 8’x8’ platform today…. Probably 2 1/2’ high. Planning on grabbing some horse stall mats tomorrow but wondering how y’all attach blind to platform? Do y’all bolt it through the flange? How big of bolts if so…

[Electrican]

I just used wood screws with fender washers. Worked great.

[popeandyoung151]

I actually put my blind on my platform today. I just used 3” self taping roofing screws around the edge. Sprayed flex seal on top of them. Not saying this is the right way but it’s what I did.


Sent from my iPhone using Tapatalk

[jerp]

I just used wood screws with fender washers. Worked great.

That’s what I did - just every 24” or so. Stayed put in some really high winds

[Big pig]

Building my new platform this week
Thanks for the question

BP

[Krivoman]

Just an fyi. On the inside of blind there is an inner lip to screw through. That way you dont ha e jokes on the outside. :-)

[Bisch]

I used 4 bolts with fender washers evenly spaced around the flange.

Bisch


Sent from my iPhone using Tapatalk Pro

[Bish]

Do as Mitch stated, that's what I did, I did 8 4'' bolts around outside flange and then every 5'' apart I put 1.5'' wood screws around on the inside, that baby is tight and no gap's at all.

God Bless
Bish

[Snowflake Killa]

We put the stand on 2 sheets of ¾ in tongue and groove plywood traced the stand. Cut it back 1 inch short then screw it down. This way the water won't run in the stand.

Sent from my SM-N986U using Tapatalk

[Kingfisher789]

Shoot. All those are going to work. Good job.

[ByronB]

I used wood screws on the lip. Works just fine. Mine is on a six foot platform