Since I’m possibly one of the most impatient folks in the world and before I blow a gasket.....I could use some help on the basics of how to reset the zero stop on a Vortex Viper PST Gen2. I mounted the scope and bore sighted it. I didn’t do any of the things you see on the videos since I watched them and read the directions after the fact. I sighted it in with 4 shots and then decided to figure out how the thing works. I have been the 3x9x40mm kinda fella for 35 years so I’m not accustomed to this nice stuff. I loosened the screws and set the turret back to zero which is the zero stop. BUT the inner turret is on 5 and the outer turret, after setting the zero stop to zero, is on on 1 revolution. Should the outer turret be on zero and zero revolutions? If it wasn’t three acts of Congress to post a picture I would but....
Announcement
Collapse
No announcement yet.
Setting Zero Stop on Vortex PST Gen2?????
Collapse
X
Comment