Cut a 2 inch section out of the outside lip with your cut off wheel...rotate the center piece till one of the bolts is visible, cut it off, rotate and repeat till all three have been cut, lift lid out.
Cutting slot from the outside is the hardest part, I have removed 2 of those from old house remodels but they were empty..
Cut a 2 inch section out of the outside lip with your cut off wheel...rotate the center piece till one of the bolts is visible, cut it off, rotate and repeat till all three have been cut, lift lid out.
Cutting slot from the outside is the hardest part, I have removed 2 of those from old house remodels but they were empty..
Well folks I am sorry to say but this may have a crappy ending finished removing the concrete from the top plate and it will not budge. Must be a bottom plate as well.
If you give up that easy after all this we will start a GoFundMe for a bus ticket to send Burnadell over there to give you a arse whoopin.
If everyone who posted donated $1 to the cause for each post, OP could have afforded that locksmith to come out already. GoFundMe not a bad idea at this point.
If everyone who posted donated $1 to the cause for each post, OP could have afforded that locksmith to come out already. GoFundMe not a bad idea at this point.
Get small funnel and fill previous hole with gun powder and place a fuse in it. Light and run, the safe will be open and contents might still be salvageable.
Comment