Just curious if anyone has some help. Almost complete after Harvey rebuild and we are going to stack the washer and dryer for more room and build a cabinet for storage where the dryer was located.
I am tired of the flimsy flex hose and getting bent and kinked upon install. I would like to use a 6'piece of 3" PVC to run from the near the dryer, 90 out the wall and install my vent screen onto the end. I would have to run the pipe through the back of a 24" wide cabinet but I can't see it being an issue. It would be a horizontal run, about 18" off the ground
I have no desire to run the flex at all, even though it's metal. We have smart dryer that's eco friendly and the discharge heat is very little, it's like it cools the air before it exits?
Any input?
I am tired of the flimsy flex hose and getting bent and kinked upon install. I would like to use a 6'piece of 3" PVC to run from the near the dryer, 90 out the wall and install my vent screen onto the end. I would have to run the pipe through the back of a 24" wide cabinet but I can't see it being an issue. It would be a horizontal run, about 18" off the ground
I have no desire to run the flex at all, even though it's metal. We have smart dryer that's eco friendly and the discharge heat is very little, it's like it cools the air before it exits?
Any input?
Comment