So I pulled my boat out last week and hooked it up to the water hose so that I could start it before I get time to get out. Of course, it has sit all winter. (I drained and winterized it, ran all the fuel out etc). I pumped the bulb and choked it a few times before she finally fired. Idled it for about 3-4 minutes, disconnected the water hose and put back in the shop. I few days later I noticed this oil on the floor....is it just “blow-by” from not being run, oil too rich or do you think I need to replace the seal around the prop shaft?


Sent from my iPhone using Tapatalk


Sent from my iPhone using Tapatalk
Comment