What is the best insert glue?

[ultrastealth]

I've used epoxy and cyanoacrylates, and had inserts pull out with both kinds. Mind you, I prep the inside of my shafts with alcohol prior to gluing. Is there something superior out there?

[LeanMachine]

What brand CA glue are you using? I have always had great success with loctite. Only way one will come out is if I bury an arrow into a wood target frame or tree. Takes a lot of force, typically rotational, to get the arrows out then and it will cause the bond to fail.

[cuttingedge]

Use denatured alcohol to clean the arrow and the insert. Loctite gel will work. I also like AAE Fastest fetching glue and Easton Insert glue. All are "super" glues with quick set and cure times

[jerp]

I use Bohning Insert Iron and have never had one come out. The only downside is you need to let it cure overnight - it dries much slower that Loctite but it is dang sure permanent in my experience.

[SaltwaterSlick]

I like JB-KWIK. It bonds well to the carbon/aluminum combination and if you need to remove the insert a little heat applied to the insert with a soldering gun, it will pop out without damaging the carbon shaft... The Loctite CA gel works good for me as well.

[popup_menace]

I hope I don't jinx myself, but I've had great success with G5 blue glue. That stuff just won't let go. Now, this means that once it is in there, it ain't coming out.

[twdjr]

Gorilla impact tough formula super glue!

[adam_p]

Insert Iron stuck some inserts in arrows that I could not get to stick otherwise.

[Brinkley]

Gold Tip "Tip Grip" is awesome as well.

[Passafist]

Gorilla glue seems to be working just fine for me

[LUCKY AGAIN]

Gorilla glue has never failed me.

I used to use bohning hot glue

[Bowtech Lefty]

Another vote for Gorilla Glue!