Foam pads for putting on truck bed rails under toolbox

[Bill M]

Where can I find some? Been looking everywhere on line. Would like the type of foam advertised as Kaisan foam but not in layers and about 1/2" thick. Any ideas or sources?

[AddisonOil]

Bill, I always used a bike inner tube. You can buy one at Walmart for a couple bucks.


Sent from my iPhone using Tapatalk

[Ironman]

You could cut pieces off of a stall mat from TSC.

[Matthew]

Bill,
I can send you some 1/8" thick neoprene. It would probably last a lot longer than the foam strips.

[Bill M]

Thanks for the suggestions guys. Matthew thank you for the offer but not necessary. I have some thick foam but am looking for a possible alternative due to how tight I would have to tighten the bolts to compress it . Either that or trim it and y'all know how it is cutting foam.

[jhuckaby]

I always used the foam door and window weather stripping that you can get at hardware stores. Comes in rolls and different widths and thicknesses.

[Goldeneagle]

I always used the foam door and window weather stripping that you can get at hardware stores. Comes in rolls and different widths and thicknesses.

This ^^^^^.

[LWolken]

I used some 2" wide 1/4" thick foam tape gasket material. How about some rigid foam insulation board if you need 1/2" spacer?

[Quackerbox]

We always put a strip of the carpet used in schools and offices. Carpet up and rubber side down

[cbd10pt]

You're in East Texas. why you asking. You know to use gorilla tape and spray . Lol

[Olphart]

You're in East Texas. why you asking. You know to use gorilla tape and spray . Lol

No, he be west of I-45. Dat be Central Texas.

[Storm]

Cutting that foam is easy if you use a hot knife.

[JerryC]

Use some of the conveyor belt material from TSC. about 4" wide and 1/4" thick, hard rubber material.