HELP! Sight maxed out to the left but I need to go further

[TexasPigHunter]

I'm shooting groupings two inches left but my sight is maxed out on moving any further left.. What can i do to fix this? I was reading somewhere that to sight in your sight you follow your arrow which I know and do but when adjusting your rest you do that opposite. Should I mess with the rest by moving it right to help give me room to move my sight to the left?

Elite energy 32
29" draw 63 lbs
28 " carbon express mayhem 350
2 in blazer vanes
125gr broadhead
Qad rest
Trophy ridge react sight

[lbbf]

How are your broad heads grouping compared to field points? I bet you need to move your rest to the right just a touch. Is your arrow point in line with the string? Is your sight in line with the string and arrow? They should all be close. Just a couple of things to check.

[lbbf]

Also look at cam lean. Is your axel to axel even on both sides?

[Buff]

Move your rest

[Cajun Blake]

Move triangle reference point to 7/8 and shoot

[Mr Sid]

Moving rest might work, but will change arrow flight. You move rest (slightly) to get best arrow flight, not sight in. You have other problems w tuning. As stated above, also arrows may be over spine.

[enewman]

Lot of elites tune at 15/16. Where is your center shot.

If your sight of maxed out. Then you need to check some things.

Are you really tuned
What does cam lean look like. You may need the shim kit for the elite.
Your form/grip/draw length may be off a little.

I believe elite likes there cams in sync also. If out this can cause some tuning issue. This is best set with a draw board. Go to there web page it shows you how to set

Take one of your arrows cut the fletchings of it. Back up at 20'yards and shot one fletch and the bare at same spot and see what it looks like.

And your not over spine. That bow at that draw weight and your draw length requires a 340 spine arrow

[Jmh05]

Maxing out to the left and still needing room. Check your rest. Something isn't right.

Also, you may need to paper tune...

[Texas89]

Get it to a good shop and have them take a look

[rockone8]

Bring it to me at the Cabelas in Waco and we will fix it for free! I will set up your center shot with a laser and then we will go from there.

[doppelganger]

I think QAD has a kit or something to help move it further left. give QAD a call, I think I had the same issue on an older rest and they sent me a different set of screws for it