A lot of machinists are laid off right now, this may be your chance to make a few bucks.
I am POSSIBLY looking at a job coming up that will require about 40hrs per week for about 5 weeks. Requirements are that it will be contract labor, must know Fanuc OM Controls and be able to set up and run unassisted. There is no room for scrap. Must pay attention and run good parts. This is semi production so it is actually easy work for a good CNC machinist. Hours worked will be up to you but job must be completed on time. Must be cautious and careful while being productive. Must work safely. Pay will depend solely on candidate but looking at somewhere around $30/hr. At this time this is tentative, no guarantees.
Located in Plantersville area ( between Conroe and Navasota )
If it matters this is all vise work, 30x16 Leadwell VMC
Please post or pm for email or phone number
Thanks
I am POSSIBLY looking at a job coming up that will require about 40hrs per week for about 5 weeks. Requirements are that it will be contract labor, must know Fanuc OM Controls and be able to set up and run unassisted. There is no room for scrap. Must pay attention and run good parts. This is semi production so it is actually easy work for a good CNC machinist. Hours worked will be up to you but job must be completed on time. Must be cautious and careful while being productive. Must work safely. Pay will depend solely on candidate but looking at somewhere around $30/hr. At this time this is tentative, no guarantees.
Located in Plantersville area ( between Conroe and Navasota )
If it matters this is all vise work, 30x16 Leadwell VMC
Please post or pm for email or phone number
Thanks
Comment