How much would materials for this cost?

[TxAg]

[ATTACH]717325[/ATTACH]

[Jayt22]

Would need dimensions but wouldn't think it would be that much

[TxHunter06]

Like mentioned above depends on dimensions and type of material, but just a wild guess I'd say in the $2-300 range.

[Pineywoods]

Looks like white pine...without dimensions if guess 400 range for materials

[Electrican]

My guess would be upwards of 400

[mavrick]

You are looking at better than $500 maybe closer to $600.

[PEC]

You are looking at better than $500 maybe closer to $600.

X2. White pine is not cheap and there are way more boards there than you probably think.

[curtintex]

$8,000,000,000 worth of labor.

[tradtiger]

You are looking at better than $500 maybe closer to $600.

Whatever you think it will cost -- say $500 -- add half again. Lumber and hardware always end up costing more than you think on a new project. Bear in mind, that structure has to be made to come apart, but also to hold together safely. Looks really fun, though!

[Mertzon Man]

$8,000,000,000 worth of labor.

Lol, true!!

[fishingsetx]

Without seeing the plans, Id guess it would cost more than what you can buy it for. $700+ for materials (50 8' 1x4 appearance grade, 5 8' 1x6 a. g., 12 2x4's, 12 1x2's) plus hardware, pipe, sand paper, paint, stain, sealer and brushes). Then the time and labor to put it all together. I'd pay $1000-$1200 for it if I was in the market before I would attempt to build it! You could save a little money going with standard boards over appearance grade but the savings would be ate up in labor and scrap.

[gumbl3]

Quite a bit, you could use T111 then just cap your treads and tops with nominal lumber if cost is a concern. Would need to trim the corners if you went the route. Gonna be heavy! the black iron pipe is relatively cheap though