Average turnaround time for muzzle threading and break installation

[canny]

I have been after my dad for a few years to have his 300 RUM threaded and a break installed. He always talks about how hard it recoils. Come to find out one of the tenets in an industrial complex he owns is a gun smith. I went with him one day and was able to check out the guys shop and view some of his work. I told my dad to go ahead and have the guy do the work as I felt he was competent to do a good job. Here's the kicker, it's been 2 months and no results.

So I'm asking the GS, what is the typical turn around time to thread, install break, and contour break to match barrel dia?

[Dushon]

Average turnaround time for muzzle threading and break installation

Every one will be different. But, he should have let you know an expected turn around time. I got one done about a month ago and it was ready in 2 days
That was just threaded though. No break

[bear]

The gunsmith knew we were coming and had the lathe ready when we showed up. Everything was done in a few hours....

[Boss Buck]

A week, 10 days at the most. IMO, unless stated orther wise at time of drop off.