I am an idiot. Stic knife problems.

[cantexduck]

Well , you know when you are doing something and you think , little more pressure and I bet it will break...... it happened. Again.

Wind blew open the stand door and bent the hinges. Snuck into the stand somehow with out running these off .

Door would not latch so I was attempting to pry between the door and blind frame.
I have worn this edc for close to 3 years. Everyone loves the moose palm sides.
Frank , can anything be done with it ?

[DCT]

I'll take it! Sorry had to. That sucks nice looking Stic.

[Antlers86]

Noooooooooooooo!!!!!

[Burnadell]

Round off the point and make a skinner.

[Hunter_Man]

I'm with burn. Reshape it and sharpen. Use it again!

[akey]

That is heartbreaking! Using a custom made knife as a prybar is a huge pet peeve of most knife makers. Reshaping would be the only recourse. Sorry that happened to you!

[sharkhunter]

I just gave a safety class at work about using the right tool for the job :-)

[Matteo]

Yup. Shorter blades have more prying leverage too! Heheheh

That'll learn ya!

[cantexduck]

Ha. When it happened I let out a nice word. Hogs ran off.

[Black Ice]

I can't look.

[Kevin Smith]

Grind the end to look like a flat blade screw driver.

[AntlerCollector]

Your Stic knife license has been revoked!

I will PM you to address for you to turn it in asap

[cantexduck]

The blade seems magnetic. Why is that ?

[18ncs]

Looks like you could grind it down a little and shuck oysters with it

[akey]

Ha. When it happened I let out a nice word. Hogs ran off.

I use magnets for different tasks when I make a knife and the blade always seems to pick up a little bit of it.