2013 ranger midsize help

[JDL]

I need a favor. Anyone have one of these in their garage that could grab some measurements for me?

I need two measurements:

1. Inside top edges bed width

2. Length of bed side before the curve on the front and the back.

Can anyone help me out?

Thanks in advance!

[JDL]

this is a quick skecth of the measurements i need

[Josh7099]

I have a 2011 400 but I'm not sure they are the same. If you think they are I will go measure it for you.

[Bisch]

I have a 2008, so I'm no help!

Bisch

[JDL]

I have a 2011 400 but I'm not sure they are the same. If you think they are I will go measure it for you.

Man it should be the same. I compared the specs online.

[Josh7099]

Ok I'm headed outside to measure it.

[Josh7099]

It's 28 3/8" on the sides before the curves and 46 1/8" inside of top edge. Hope this helps.

[JDL]

It's 28 3/8" on the sides before the curves and 46 1/8" inside of top edge. Hope this helps.

Sure does hoss. Thanks!!

[Josh7099]

No problem.

[Blue Tick]

What are you making for the mid sizes?

[thebowhunters]

I have 5 of them, will get with you in the AM

[JDL]

I have 5 of them, will get with you in the AM

Cool. Thanks!

[JDL]

What are you making for the mid sizes?

High seats!

[Huntin]

We are doing the same thing right now. We have a mid size 2012 and Josh7099 measurements are correct. Here is a drawing that I made up and we modified it a bit. Ours will be a low seat with your feet resting on the floor of the bed.

[Blue Tick]

High seats!

Sure wish you were closer.